I have a Viewsonic made in 1998, G810 model, 21VS001 chassis with similar symptoms. The picture would pulsate as well, but no squealing noise. It looked like the input AC was going up and down. I wonder how similar our 2 chassis' are. I had to totally dissemble the monitor and reassemble it with the chassis hanging off and I forgot to connect the picture tube DAG to ground. Now the HV comes up and the monitor goes into shutdown immediately. Do I have 2 problems now, or is the flyback bad like yours? Kevin Wilks Kevin's TV & Video Repair Penticton BC Canada kevintv@xxxxxxx -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of Don Hartigan Sent: Friday, May 28, 2004 11:31 AM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Fw: Viewsonic-E771,mod#VCDTS21532,Pulsing > This unit uses FBT7010,which is squeeling & the HV is pulsing .The HOT & > fets check ok.If I remove Q402=C5386 I can scope a good waveform on it's > base.Are FBT's a problem with this unit & will I require DAS to align this > monitor?..TIA.. > Don of HARTS-TVCR''ASC'' > 9 Robert St,Oromocto,NB,Can,E2V3N2 > hartstv@xxxxxxxxxxx > Tel-5063579785,fax-3576010 > cel-4701719 > ------------------------------------------------------------------------ ----- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/