try this CTC/PTK195 No Vertical deflection all output parts seem OK replace C14501 and C14503 off pin 16 U16201 Also check CR14703 and R14705 +13 volt supply off flyback Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Monday, September 13, 2004 12:02 PM Subject: [TechAssist] Fw: RCA P60920BL (CTC195K) Vertical Problems > Well this set still does the same thing even after replacing several parts > in the vertical section that are listed below. Has anyone seen this chassis > do this? It works fine for about 2 or 3 hours then is starts to shrink down > to a line. > > Shaun > > Advanced Electronics > 224 West Riverview Ave. > Fort Morgan, CO 80701 > ----- Original Message ----- > From: "Shaun" <satguy@xxxxxxxxxxxxx> > To: "tech" <techassist@xxxxxxxxxxxxx> > Sent: Sunday, September 12, 2004 6:13 PM > Subject: RCA P60920BL (CTC195K) Vertical Problems > > > > This set will run for up to 2 hours fine then the picture will start to > > shrink from the bottom first till it is just a line in the middle of the > > screen. I replace the vertical IC (U14501) and C14505 (35 v 220 uf) along > > with R14502 (220 ohm 1 watt). I need the value of R14512, when I freeze > > spray around R14512 which is very discolored, the set goes back to normal > > operation. I also need the value of R14305, it is also discolored. Thanks > > for any help and any other tips someone might have. > > > > Shaun > > > > Advanced Electronics > > 224 West Riverview Ave. > > Fort Morgan, CO 80701 > > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/