Thanks for everyone's help. there is no 12V to pin 1 of LA7835 VCC1. Nearby fusible resistor is ok. I wasn't even looking for this voltage I was only looking for 25V but now i notice related 12V voltages missing everywhere. IC202 (TO-220 with snap on heat sink has 17.5 volts in nothing out. Pin 2 is gnd. No diode or resistance measurements between the input and output. L7-M08 or ECG 964 Don't have a print but I think I'll try a new IC Craig n a message dated 9/29/03 9:49:23 AM Eastern Daylight Time, peggs@xxxxxxxxxxxxx writes: << May be a B+ missing to the Jungle IC's Vertical Osc./Drive circuuitry. I seem to remember these having solder problems on the TO220 regulators. They are heat sink mounted Peggs At 08:17 PM 9/28/03, MYERSVCR@xxxxxxx wrote: >Pulling my hair out on this one. >25V present >vert input present >no vert out on LA7835 >replaced R467 which was bad then >replaced LA7835 3 times >resoldered everywhere including flyback related circuitry >ESR'd all caps and replaced 7 in vert sect which were actually good. >cannot find any resistors, diodes, caps etc that are bad. what am i missing? > > >Craig Myers >Myers Electronics >610 Salem Ave >York, Pa 17404 >> ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/