David,This set uses ''AKB'' auto-kine-bias,IC801=ECN2511,therefor no R,G,B, pots or adjustment.It ''may'' be your problem but I would check the emmision on guns first.Tube may be weak.You can also try adjusting the G2 for a better pix,ie color versus tint.It helps sometimes.If you do a clean/rej on the tube do on a low setting.....regards....... Don of HARTS-TVCR-ASC 9 Robert St,Oromocto,NB,Canada,E2V3N2 Tel-506-357-9785,Fax-506-357-6010 hartstv@xxxxxxxxxxx ----- Original Message ----- From: "David Lessard" <mrfixit@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, January 29, 2003 9:38 PM Subject: [TechAssist] Emerson TV TS2760 Chassis ? > > Gentlemen, this may be one of those stupid questions, how do you adjust the > RGB drive levels on CRT. There are no pots on CRT board. Only color, tint > and brightness on main board. Any help would be appreciated. > > David Lessard > 50 Harrison Street > Alexandria Electronics > Ontario, Canada > K0C-1A0 > mailto:mrfixit@xxxxxxxxxxx > > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html