Fernand,IC402 gets it's 12vdc i/p from pin 10 of flyback thru R439=2.2ohm &D402,filtered by C437=1000ufd/25vdc.The 9volt o/p of IC402 feeds various pins on IC201=TA8654AN.......HTH...Don...... HARTS-TVCR''ASC'' 9-Robert St.,Oromocto,NewBrunswick,CAN Tel#506-357-9785Fax#506-357-6010 ----- Original Message ----- From: "Fernand Goguen" <fgoguen@xxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, May 02, 2002 3:45 PM Subject: [TechAssist] EMERSOM MS1980 NO sound, HV OK > Went on a service call for a complaint of tv clicking off when either vol. up or dn was depressed either on the remote or front panel of tv. Opening up the set I found C507 100uf 160 volts had leaked and had eaten traces on circuit board. Replaced with 250 volts I had on hand. Set played for 2 hours and went out again. This time it would not come onwhen I used remote or front panel switches. I resoldered around scr and other parts in horiz section. I now have H.V. but no picture, no sound. Heater does not light. I have a regulator IC402 7809 and I do not have any voltage at input or output. I would appreciate a scan of this set or if someone could tell me where the b+ for the above IC comes off the scan derived voltages. > FERNAND GOGUEN > GOGUEN TV SERVICE > fgoguen@xxxxxxxxxxxxxxx > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/