I usually replace both IC's , better use the original ones than replacement. I have an experience that I replace only 1 IC's but after sometime, the other one breaks down also. Dennis Co dennis@xxxxxxxxxxxxxxxxx ----- Original Message ----- From: "Wadsworth" <wadsword@xxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, October 22, 2002 7:32 AM Subject: [TechAssist] Convergence problem Toshiba PTV TP48D90 > Hi All, > > I'm working on this set for the second time. The first time was a few > years back and I replaced the complete convergence module (#PB4613-1). > This part is now disco'd by Toshiba. Can anyone help identify which > chips would be likely suspects to replace on the module? There are two > large IC's QJ03 and QJ04. They are part #s PA0036 and PA0058. Any SK > replacements available for these? Also, I'm working without the > schematic, so any other tips are appreciated. > > Thanks in advance, > Don > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/