Is there a vertical pulse getting to the IC? What is the chassis number? Are you using a scope? Dominic DiLeo Atlantic TV Freeport, Maine ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ In a message dated 12/8/04 10:02:34 AM Eastern Standard Time, hivolts@xxxxxxxxxxxxxxxx writes: << Hi All I have been going around and around with this one.I still can't find why I have no Vert on the set.I have my 12V,25V,in and out of the chip (IC 451 la7838)I have rang the yoke it ck good and i have almost shot gunned the vert cir any ideas on this would be a graet help Hi all I hope everyone's thanksgiven went well.I'm working on this TV It came in dead soldered bad solder on power reg ic and replace the horz output.set came on but with no vert. so upon checking the ic 451 I found it had blown out so I replace it still no vert out put.So far I have replaced R461,IC451,R810,D812,C451,C455, and check all the caps and diodes in the vert line still no vert any one seen this before an help I would love to here from any one Chuck Staples Staples T.V. Phippsburg Maine 04562 >> ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/