You can use the reservoir on a late bay master cylinder on an Early Type 2. Then you have the fill hole lining up with the access hole under the floor. *it* was cheaper than installing a 67 dual circuit. I think there's a little market force at work here. I now know I'll go and snag these buggers out of pick a part yards. -----Original Message----- From: tcb-bounce@xxxxxxxxxxxxx [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf Of Lonnie Bergman Sent: Sunday, April 30, 2006 2:01 PM To: tcb@xxxxxxxxxxxxx Subject: [tcb] Re: need a master cylinder resevior for a 1978-1983 rabbit Are you putting the rabbit master cylinder on a splitty? -----Original Message----- From: tcb-bounce@xxxxxxxxxxxxx [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf Of Will Wood Sent: Sunday, April 30, 2006 12:56 PM To: tcb@xxxxxxxxxxxxx Subject: [tcb] Re: need a master cylinder resevior for a 1978-1983 rabbit Yikes I just ordered two of these three months ago..! $89 for this one http://www2.cip1.com/ProductDetails.asp?ProductCode=VWC%2D867%2D611%2D301%2D B Time to go bone yard hunting at pick a part.. :-( -----Original Message----- From: tcb-bounce@xxxxxxxxxxxxx [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf Of singlecabboy Sent: Sunday, April 30, 2006 12:32 PM To: tcb@xxxxxxxxxxxxx Subject: [tcb] Re: need a master cylinder resevior for a 1978-1983 rabbit Will , I found the master cycider , where did you find the resevior for the Rabbiton cip1? --- Will Wood <evilscientistboo@xxxxxxxxxxxxx> wrote: > CIP1 sells them for $50. > > > -----Original Message----- > From: tcb-bounce@xxxxxxxxxxxxx > [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf > Of singlecabboy > Sent: Sunday, April 30, 2006 3:28 AM > To: tcb > Subject: [tcb] need a master cylinder resevior for a > 1978-1983 rabbit > > found on e at Bus Depot for 102.00 (German ) ouch! > know of any water cooled sites? > > > > > Paul Smith www.23window.com/thezone Praise The Lowered T.C.B. H.B.B.