Yeah it seems so. Do you know where I can get a small amount of sheet aluminum? Sent from my iPhone On Oct 12, 2010, at 1:04 PM, wuzmop@xxxxxxx wrote: > THanks! > > Eric, that is alot like the ones I made, but mine are only an inch wide. > Width appears to be the key! Mine have worn the seat back because they are > too narrow. > > > > -----Original Message----- > From: ATX BUS <atx_bus@xxxxxxxxx> > To: tcb@xxxxxxxxxxxxx > Sent: Tue, Oct 12, 2010 12:51 pm > Subject: [tcb] Re: Z-bed brackets on firewall? > > Robb, > > I'll take a pic when I get home from the office. > > Congrats on the job!!! > > Jeff > > > > From: "wuzmop@xxxxxxx" <wuzmop@xxxxxxx> > To: tcb@xxxxxxxxxxxxx > Sent: Tue, October 12, 2010 11:57:32 AM > Subject: [tcb] Re: Z-bed brackets on firewall? > > Jeff, can you email me a pic? I've never even seen one, just guessed when I > made mine. > > > > -----Original Message----- > From: Eric Woodall <ericthomaswoodall@xxxxxxx> > To: tcb@xxxxxxxxxxxxx <tcb@xxxxxxxxxxxxx> > Sent: Tue, Oct 12, 2010 11:48 am > Subject: [tcb] Re: Z-bed brackets on firewall? > > I'll definitely hit you up if I can't find one. Thanks Jeff! > > Sent from my iPhone > > On Oct 12, 2010, at 11:30 AM, ATX BUS <atx_bus@xxxxxxxxx> wrote: > >> Eric, >> >> I have some brackets to use as a template. They are from a splittie. >> >> Jeff >> >> >> >> From: "wuzmop@xxxxxxx" <wuzmop@xxxxxxx> >> To: tcb@xxxxxxxxxxxxx >> Sent: Tue, October 12, 2010 9:11:03 AM >> Subject: [tcb] Re: Z-bed brackets on firewall? >> >> Just some steel flat bar crap I found at home depot, riveted in. After 6-7 >> years it's time for me to revisit my design. >> >> >> >> -----Original Message----- >> From: Eric Woodall <ericthomaswoodall@xxxxxxx> >> To: tcb@xxxxxxxxxxxxx <tcb@xxxxxxxxxxxxx> >> Cc: tcb@xxxxxxxxxxxxx <tcb@xxxxxxxxxxxxx> >> Sent: Tue, Oct 12, 2010 7:56 am >> Subject: [tcb] Re: Z-bed brackets on firewall? >> >> Did you make them with some plate steel? >> >> Sent from my iPhone >> >> On Oct 12, 2010, at 7:33 AM, wuzmop@xxxxxxx wrote: >> >>> I had to make mine. >>> >>> >>> >>> -----Original Message----- >>> From: Eric Woodall <ericthomaswoodall@xxxxxxx> >>> To: tcb@xxxxxxxxxxxxx >>> Sent: Tue, Oct 12, 2010 7:31 am >>> Subject: [tcb] Z-bed brackets on firewall? >>> >>> Not sure what these are called but I need some of those triangular brackets >>> that >>> bolt to the firewall and give support to the seat back when in bed mode. >>> Don't >>> care if they are bay or split. >>> Anybody have a set they would part with? >>> >>> Eric >>> >>> Sent from my iPhone >> > = >