The liner step is there to protect your case.you don’t need it. But you might
wish you had it, if your case blisters or burns through at that point.
You could drill it on a drill press . Or setup a router to cut it.i can do it
for you on the lathe if you want.
On Jun 21, 2019, at 1:45 AM, Bruce Beck <bbeck7@xxxxxxxxx> wrote:
How much reduction do you want on the ID? Can you also reduce the OD as well?
On Thu, Jun 20, 2019 at 4:55 PM Art <dmarc-noreply@xxxxxxxxxxxxx> wrote:
If you're using 1 inch, thin wall PVC pipe you should be able the remove
some of the ID with a sharp knife held at an angle and not taking too deep a
cut. Of course the liner needs to have a clean, straight edge to start
with.
Alternatively, an extra O-ring like the one the Loki nozzles use and a
little compression fit might also work.
Mind you I have all the hardware but I've only used it with certifies Loki
reloads..... so far.
Art Applewhite
New to sugar
-----Original Message-----
From: Chuck McNeice II <capthaywire@xxxxxxxxx>
To: sugpro <sugpro@xxxxxxxxxxxxx>
Sent: Thu, Jun 20, 2019 4:49 pm
Subject: [sugpro] 38 mm PVC liner for LOKI
I would like to use a PVC liner in my 38 mm LOKI 740 motor with sorbitol
bates grains. The LOKI liner slips over the nozzle by about .25 inch. Can I
just butt the PVC liner to the nozzle or will I need to reduce the ID of the
PVC pipe? If so what is the best way to reduce the ID without a lathe or
other sophisticated tooling? Any other tips would be greatly appreciated.
