How much reduction do you want on the ID? Can you also reduce the OD as
well?
On Thu, Jun 20, 2019 at 4:55 PM Art <dmarc-noreply@xxxxxxxxxxxxx> wrote:
If you're using 1 inch, thin wall PVC pipe you should be able the remove
some of the ID with a sharp knife held at an angle and not taking too deep
a cut. Of course the liner needs to have a clean, straight edge to start
with.
Alternatively, an extra O-ring like the one the Loki nozzles use and a
little compression fit might also work.
Mind you I have all the hardware but I've only used it with certifies Loki
reloads..... so far.
Art Applewhite
New to sugar
-----Original Message-----
From: Chuck McNeice II <capthaywire@xxxxxxxxx>
To: sugpro <sugpro@xxxxxxxxxxxxx>
Sent: Thu, Jun 20, 2019 4:49 pm
Subject: [sugpro] 38 mm PVC liner for LOKI
I would like to use a PVC liner in my 38 mm LOKI 740 motor with sorbitol
bates grains. The LOKI liner slips over the nozzle by about .25 inch. Can I
just butt the PVC liner to the nozzle or will I need to reduce the ID of
the PVC pipe? If so what is the best way to reduce the ID without a lathe
or other sophisticated tooling? Any other tips would be greatly appreciated.