Well, I have been doing it the way you are talking about, but when you have 4 or 5 files you are working with to to create a 1 hour radio program sometimes us old people have to think awfully hard to remember which one of those document files is the next one I want to put into the mix. Oh, and I know you will probably groan at this one. Is there a chance of adding the ability to burn a cd directly from within SR. It would be really nice to have the entire project completed, saved, and now in the same software to be able to go ahead and burn the cd directly from the same software without having to run another software just to burn the cd. In my instance I have one 58 minute file with the entire program in the one file, but that is probably not what most people would be looking at. Probably most applications would have several files all of which they want to burn into a cd. So, if that option were added it would need the ability to choose whether the burn ended by closing the disk or not. David Tanner Rehabilitation Program Specialist 3 Assistive Technology Specialist Assistive Technology Department MN State Services f/t Blind Office- 651-642-0795 Cell- 651-270-2233 Skype name: dtat100 >>> rmeredith@xxxxxxx 6/16/2006 11:01 AM >>> Neal: In short, if you open an MP3 file, it is expected that you are, infact, working with an MP3 file, and MP3 files cannot be edited. So, even though it is decoded, and the data could be edited, if you saved, you would either have to reencode, or save the wave data as an MP3 file; neither is a good option. So, we just can't let you do that. It would be kind of like opening a Word file but word always saving it as .rtf or something like that, not good! It appears that my pitch of "Just use Save As" is not much liked. That really is the best way at the moment. If you insist, you could choose to create a new document and just insert the MP3 file. As long as the sample rates match, this will work, and you can begin editing immediately after decoding. We are considering adding an open as .wav file option. I don't personally like it much; there are issues. But, since people on this list seem to want this option, we should probably give it a look. Rob Meredith >>> neal.ewers@xxxxxxxxxxxxxx 06/16/06 10:56AM >>> Oh dear, he's back again. Well, I do have one question. Rob, if I open an MP3 file in Wave View, it says it is decoding the file. Why then, is this still a read only file. What more would have to be done to make such a file able to be edited rather than getting the message that this is a read only file? OK, that's all for today. Well, perhaps I will think of something later. Neal Ewers Ravenswood Productions Local phone: 608-277-1995 Toll Free: 888-544-8332 Email: neal.ewers@xxxxxxxxxxxxxx http://www.ravenswood.org <http://www.ravenswood.org/>
BEGIN:VCARD VERSION:2.1 X-GWTYPE:USER FN:Tanner, David TEL;WORK:651-642-0795 ORG:;SSB TEL;PREF;FAX:651-649-5927 EMAIL;WORK;PREF;NGW:DTANNER@xxxxxxxxxxxxxxxxxxxxxxx N:Tanner;David TITLE:Rehab Tech Spec END:VCARD