Dan, I presume that somewhere you have a table or list showing the layout of each of the 5? Dave ----- Original Message ----- From: "Dan Rugman" <sib-access@xxxxxxxxxxxxxxxxx> To: <sib-access@xxxxxxxxxxxxx> Sent: Tuesday, April 28, 2009 12:56 Subject: [sib-access] Re: Documentation Regarding Single-Dotted Note Vs. Sharp The documentation is wrong. It should read as follows: *** start *** Dotted notes You can add single, double and triple rhythm dots to any note. You do this through the keypad as well, and as with the other duration keys, they apply to every note which you enter from that point on. Press KeypadDecimal (KeypadDelete) in the F8 layout to add a single dot. Press Keypad2 in the F9 layout to add a double dot. Press Keypad3 in the F9 layout to add a triple rhythm dot. *** end *** In case there's any confusion, the single rhythm dot is in the F8 layout and the double and triple dots are in the F9 layout. Dan Rugman visit the new on-line resource for visually impaired musicians and home of Sibelius Access. www.musicaccess.co.uk -----Original Message----- From: sib-access-bounce@xxxxxxxxxxxxx [mailto:sib-access-bounce@xxxxxxxxxxxxx] On Behalf Of Dale Lieser Sent: 25 April 2009 20:37 To: sib-access@xxxxxxxxxxxxx Subject: [sib-access] Documentation Regarding Single-Dotted Note Vs. Sharp Reading through the editing documentation, I appears the single dot command and the sharp are listed to have the same key stroke--keypad8 in the f8 template. The double and triple dots come from the f9 template. What am I missing? Dale Dale Lieser Music Assistant Southwest Baptist Church 1300 SW 54th St Oklahoma City, OK 73119 405/682-1491 x220 dale.lieser@xxxxxxxxxxxxx If you wish to unsubscribe, send a blank message with the single word, unsubscribe - in the Subject line to: sib-access-request@xxxxxxxxxxxxx If you wish to unsubscribe, send a blank message with the single word, unsubscribe - in the Subject line to: sib-access-request@xxxxxxxxxxxxx If you wish to unsubscribe, send a blank message with the single word, unsubscribe - in the Subject line to: sib-access-request@xxxxxxxxxxxxx