Hello Scott, I have encountered a problem in simulating the ibis model in hspice. From the IDT's web , i downloaded the IDTFCT163244's IBIS(v1.1) and Hspice model and runing it under the Hspice. Both using the same line(Zimped=50 , Tpd =1ns , T-line element in hspice )and terminate ( end terminate to gnd with 50ou ). When compared the result of each other they are similar in general. But the timing delay is different ,for rising edge , the spice model's result have more delay than IBIS's , it's about 1.58ns. but for falling edge ,the IBIS model have more delay about 330ps . so the result looks like spice result pulse width was a little narrow than the IBIS result. The ibis model doesnt have Rising and Falling Wave , which only have the Ramp, but without R_load . looks like it ..... ....... [Ramp] | variable typ min max | dV/dt_r 1.88/0.57n 1.67/0.89n 2.08/0.38n dV/dt_f 1.91/0.50n 1.72/0.78n 2.09/0.34n [End] Has anyone done work in this and know how to solve it ? any help is appreciated :-) I have captured the pic of the result ,if someone have interest with it i will send individual. -- Best regards, qzheng mailto:qzheng@xxxxxxxxxxxxxxxx ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu