[SI-LIST] milliohm measurement probe and cable

  • From: "ben chia" <bchia@xxxxxxxxxxx>
  • To: "'Si-List'" <si-list@xxxxxxxxxxxxx>
  • Date: Thu, 9 Oct 2014 10:11:47 -0700

Hi All, 

I try to measure the package VCC or VSS resistance to match the simulation
report from vendor. Vendor said that the resistance should be less than 2
milliohm from bump to ball. The setup in my lab is Agilent multi-meter ( up
to 1 milliohm resolution, 4 wire ). I use GGB 40A 150um center pin to touch
the bump. A 26G coax cable to connect the probe to multi-meter. The measured
result is stable up to 1-2 milliohm, but resistance value is more than tens
of milliohm. Can anyone recommend a different setup? 


Ben Chia
High Speed Design Center

To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List forum  is accessible at:

List archives are viewable at:     
Old (prior to June 6, 2001) list archives are viewable at:

Other related posts: