Samsung Enterprise Portal mySingle P { MARGIN-TOP: 5px; FONT-FAMILY: ±¼¸², arial; MARGIN-BOTTOM: 5px; FONT-SIZE:9pt } TD { MARGIN-TOP: 5px; FONT-FAMILY: ±¼¸², arial; MARGIN-BOTTOM: 5px; FONT-SIZE: 9pt } LI { MARGIN-TOP: 5px; FONT-FAMILY: ±¼¸²,arial; MARGIN-BOTTOM: 5px; FONT-SIZE: 9pt } BODY { LINE-HEIGHT: 1.4; MARGIN: 10px; FONT-FAMILY: ±¼¸², arial; FONT-SIZE: 9pt } Dear everyone, This is my first trial to ask question on SI-LIST. Wish everyone is welcomimgwith my question. 1) when I see the HDMI compliance test report(H/W), the Rise/Fall time spec is >=75.000ps . why the spec is >=75ps, not <= (max time limit) ? I think the rise/fall time should be shorter for better SI performance. Is there any specific reason for restricting rise/fall time to be larger than75ps? 2) Now my system has a problem with EYE test on 1080 60p with 148.5Mhz. The envelope of Rising signal is touching the EYE MASK since the envelope is too slow. (rise time is 290ps) Would you please share some methods to make shorter rise time on the system? ( I tried the pre-Amphasis option for boosting signal, but it causes criticalovershooting which i can't accept) * the trace lane impedance is about 100ohm in this system. Best Regards, Chang [IMG][IMG] ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu