Shawn severe overshoot is never a good thing. The clamp diodes will try to protect the chip, but the large currents that result can cause soft error, and long term reliability problems. You will be well served to keep this problem under control by fixing the overshoot or at least limiting the current. Steve. Shawn Zheng wrote: > Hi, > I began to suspect something I did before wasn't right. For a simple > topology of a driver and several receivers, I will add serial resistors if > necessary to dampen the waveforms at receivers. However, > overshoot/undershoot at the driver's side was always ignored. I wonder if > the driver's buffer is ok in this case when large overshoot or undershoot > occurs at driver's pin or pad. Thanks. > > > > Shawn > > > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > List technical documents are available at: > http://www.si-list.net > > List archives are viewable at: > //www.freelists.org/archives/si-list > or at our remote archives: > http://groups.yahoo.com/group/si-list/messages > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > > > > -- Steve Weir Teraspeed Consulting Group LLC 121 North River Drive Narragansett, RI 02882 California office (408) 884-3985 Business (707) 780-1951 Fax Main office (401) 284-1827 Business (401) 284-1840 Fax Oregon office (503) 430-1065 Business (503) 430-1285 Fax http://www.teraspeed.com This e-mail contains proprietary and confidential intellectual property of Teraspeed Consulting Group LLC ------------------------------------------------------------------------------------------------------ Teraspeed(R) is the registered service mark of Teraspeed Consulting Group LLC ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu