Hi All, I am using Cadence PCB-SI simulator for running IBIS-AMI Channel simulation on a Serial interface. The eye diagram generated by the tool is split, with initial 1/3 part of the eye diagram appearing after the remaining 2/3 part. This does not happen if the channel length is small (1 - 2 inches). I would like to know if anyone else has observed similar phenomenon. I have taken up this issue with Cadence as well as the IBIS-AMI model vendor. Cadence response is that this is due to the model issue, whereas the model vendor says that the model works fine with other simulators. Thanks for the help. Regards, Ravinder Ajmani Server PCB Development Hitachi Global Storage Technologies Email: Ravinder.Ajmani@xxxxxxxxxxxxxx ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu