Hi Akash,
it depends on many details. If you can manage to make a very small gap between
GND and VBUS, then this might already give enough capacitace to allow the SS
signal to cross the slots.
Best Regards
Gert
----------------------------------------
HARTING Stiftung & Co. KG | Postfach 11 33, 32325 Espelkamp | www.HARTING.com
Persönlich haftende Gesellschafterin:
HARTING Führungsstiftung | Amtsgericht München | HRA 108479 | München
Vorstand: Dipl.-Kfm. Philip F. W. Harting (Vorsitzender), Dipl.-Kffr. Maresa W.
M. Harting-Hertz, Dipl.-Kfm. Dr.-Ing. E. h. Dietmar Harting,
Dipl.-Hdl. Margrit Harting, Dipl.-Ing. (FH) Dipl.-Wirtsch.-Ing. (FH) Andreas
Conrad, Dipl.-Ing. Uwe Gräff, Dr. iur. Michael Pütz
Sitz der Gesellschaft: Espelkamp | Amtsgericht Bad Oeynhausen | HRA 9021 |
UST-ld Nr. DE812136745
-----Original Message-----
From: si-list-bounce@xxxxxxxxxxxxx <si-list-bounce@xxxxxxxxxxxxx> On Behalf Of
Aakash Gupta
Sent: Monday, March 25, 2019 3:47 PM
To: si-list <si-list@xxxxxxxxxxxxx>
Subject: [SI-LIST] Caps for signals changing reference layer
Hey Folks,
I am designing a board for USB3 SS and with my current stackup, I will have SS
signals changing reference from GND to VBUS for a small portion (near another
connector).
Can I get away with it or should I used decoupling caps near the crossing, how
do I calculated the caps value?
I don't have any space for more than two caps near the connector. Any
suggestions?
--
Thanks
Aakash
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu