Hello Group ,
We seem to be running into issues while getting PCB's fabricated with 50 ohm
lines.Our Freq band of interest is 2 Ghz to 6 Ghz.Tried checking these traces
on a VNA.The return loss looks decent @ 2 Ghz , but seldom looks good at 5Ghz &
above .
The fabricator does send test coupons & impedance reports @ TDR .This does
notcover the freq response .
This is not issue with any single fab . This seems to be a general problem ,
where return loss isnot flat across freq band .
Wanted to check if there are ways to tackle this issue .
Thanks much.
RegardsSunil.B
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu