How did you PR-300 fail?
Noel Jones, AAGO
noel@xxxxxxxxxxxxx
www.frogmusic.com
Frog Music Press
636 Old 19
Augusta, KY 41002
606 756 7979
423 333 0947 cell
On May 8, 2018, at 2:57 PM, Terry Moore <tmooreism@xxxxxxxxx> wrote:
I purchased a MX-200 to replace our failed PR-300. The connection of
it was pretty straight forward. However I'm unable to save any of midi
sounds from the MX-200 to the general pistons. I have two Midi's voices
for each manual, and I can play a Midi voice on any single Midi coupler
piston, but I cannot put multiple midi voices on at the same time. And
as soon as I engage a registration from a general piston the sound
reverts to one of the built-in ones. Also, I cannot save a Midi Voice
onto a general piston. Therefore the MX-200 is usable. I'm pretty sure
I have something set-up incorrectly, but I cannot figure out what it is.
Any advice?
Thanks,
Terry Moore
St Mary's Episcopal
Laguna Beach, California
To leave this list, visit this page:
//www.freelists.org/list/rodgersorgan