Peter,
From what I've read, you can check to see if the data stream is being
transmitted from the engine by holding the camera on your phone in front of the
IR transmitter on the drawbar and see if you can see a blue glow on the camera
screen when you issue a command like blowing the whistle.
And/or if you have another Legacy steam engine with the IR drawbar, just try
that tender with your problem engine.
If neither test works and the engine won't reset I imagine the problem is
either in the IR transmitter or in the engine board the signal is transmitting
from.
Ken
-----Original Message-----
From: Peter Condro <pcondro@xxxxxxxxx>
To: rc3r@xxxxxxxxxxxxx
Sent: Wed, Jun 21, 2023 9:29 am
Subject: [rc3r] Tomorrow
As a prep for tomorrow, I went over to the store this AM and cleaned the track
on the
6x15
12x15
21x47, including the yard and I ran out of alcohol before I could finish the
station loop.
That should give us a head start on tomorrow.
I’ll buy more rubbing alcohol today.
Yesterday we got more of the club trains organized. I am stopping where I am
until I can report to the group Saturday
Train were run.
I was unsuccessful in restoring sounds to my Legacy 10 wheeler
PeterM cleaned up the bathrooms (thank you!!!!!)
PeterC