I will be there at 9:00.
On Tue, Dec 10, 2019 at 6:01 PM Thomas Gilsdorf <dmarc-noreply@xxxxxxxxxxxxx>
wrote:
What time would you like to meet?
Gilly
-----Original Message-----
From: Ken Young <dmarc-noreply@xxxxxxxxxxxxx>
To: rc3r <rc3r@xxxxxxxxxxxxx>
Sent: Tue, Dec 10, 2019 2:06 pm
Subject: [rc3r] Re: Power on inside loop
I'll try to take a look at it Wed morning.
Ken
On 12/10/2019 11:15 AM, Rick wrote:
If no one finds the issue today, I can look at it tomorrow.
Rick
On Tue, Dec 10, 2019 at 10:27 AM Walter Strohecker <wmstrohecker@xxxxxxxxx>
wrote:
Peter,
Not sure moving to the other corner will help. The receptable seems OK.
I believe the issue may be a pin in the plug.
Walt
On Tue, Dec 10, 2019 at 10:22 AM <pcondro@xxxxxxxxx> wrote:
Entire loop......it was just like shutting off the power.
Peter
Sent from my iPhone
On Dec 9, 2019, at 9:42 AM, Ken Young (Redacted sender kanawha72 for
DMARC) <dmarc-noreply@xxxxxxxxxxxxx> wrote:
Sun morning I :
- Checked power on several modules on the inside loop with a voltmeter
and didn't find any problems.
- Took the power plug apart and checked to see if there were any loose
wires and it was OK.
- Checked the back of the power receptacle for loose wires and didn't
find any.
- Ran engine on the inside loop while I twisted and pulled on the
wires to the power plug. Jiggled the power plug. Again no problems found.
For those of you running trains were the power dropouts affecting the
entire inner loop or just certain modules?
Ken
On 12/9/2019 5:30 AM, pcondro@xxxxxxxxx wrote:
Talk to Ken
he went over it with a voltmeter early Sunday
Peter
Sent from my iPhone
On Dec 8, 2019, at 10:21 PM, Thomas Gilsdorf (Redacted sender tlg225ccr94
for DMARC) <dmarc-noreply@xxxxxxxxxxxxx> <dmarc-noreply@xxxxxxxxxxxxx>
wrote:
Thanks for the pic. I think the issue is with the plug, not the socket.
There should be time to swing by and look at it this week.
Gilly
-----Original Message-----
From: pcondro <pcondro@xxxxxxxxx> <pcondro@xxxxxxxxx>
To: rc3r <rc3r@xxxxxxxxxxxxx> <rc3r@xxxxxxxxxxxxx>
Sent: Sun, Dec 8, 2019 3:44 pm
Subject: [rc3r] Power on inside loop
I got a call about 2PM that there was boo power on the inside loop. I went
and played with the plug. It was OK if I held it high. Business card fix
would no longer work......but the stiffer cardboard of the Duracell
batteries seems to work.
Hopefully, it will hold through the day. I guess we may need to move the
control center to the other corner?
Peter
Sent from my iPhone
