The screws we originally used were too short. I put ten 1 1/4" Kreg screws in.
All good now...
-----Original Message-----
From: John Crockett <dmarc-noreply@xxxxxxxxxxxxx>
To: rc3r <rc3r@xxxxxxxxxxxxx>
Sent: Wed, Dec 19, 2018 2:09 pm
Subject: [rc3r] Re: 12/19 GBGH Update
Thanks for all your repairs Tom. What happened to the raffle layout frame?John
-----Original Message-----
From: Thomas Gilsdorf <tlg225ccr94@xxxxxxxxxxx>
To: rc3r <rc3r@xxxxxxxxxxxxx>
Sent: Wed, Dec 19, 2018 2:03 pm
Subject: [rc3r] 12/19 GBGH Update
Broken track section on the bridge has been replaced. The reinforcing frame for
the raffle layout has been reattached.
There was a note left regarding DCS not working. The note indicated that the
output fuses were blown. These are 20 amp fuses, our Z4000 is good 10 amps.
Short circuit fault current might blow a fuse, but it is far more likely that
the Z4000 breaker will trip first. I found and borrowed a PS2 Seaboard Hudson
that was stored under the layout. The BAT message was displayed on the remote I
used. The batteries were replaced, engine added, started, and ran on both the
inner and outer loops. No problems. I very carefully repacked your locomotive
and put it back where I found it.
Gilly