That's right - clearance for the drivetrain was the only reason.
On 05.05.2018 06:27, Christian Winkgen wrote:
Hi Paul,
just a guess: The right side needs more clearance for chain and sprockets?
Maybe this is not really necessary.
I can see your point: I would like symmetrical better as well… :)
Cheers, Christian
Am 04.05.2018 um 23:47 schrieb paul needham <paul.2.needham@xxxxxxxxx>:============================================================
Hi all
Why are the two bends not in the same place on the right and left main tube ?
3f.
Make an incision in the inner wall of the right 40x10 tube, 17.2 cm from the
FWaP. Make a second incision 10 cm from the FWaP in the left tube. Remove the
fixing rod. Bend both ends inwards until there is only 8 mm space left between
the tire and the tubes. Tack weld both ends together. Connect the two ends with
two triangular 1.5 mm thick plates and one rectangular sized plate. Leave 2 cm
of space between the plate and the tire.
regards Paul
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jurgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to
python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================
