[pure-silver] Print exchange group
- From: walterjourdan@xxxxxxxxxxx (Walter Jourdan)
- To: <pure-silver@xxxxxxxxxxxxx>
- Date: Fri, 28 Jan 2005 10:23:48 +0100
Hi Ralph,
Can you descripe the print exchange group you are talking about?
I would be interested in a print discussion group.
Thanks
Walter
-----Ursprüngliche Nachricht-----
Von: "DarkroomMagic" <info@xxxxxxxxxxxxxxxx>
An: "PureSilverNew" <pure-silver@xxxxxxxxxxxxx>
Gesendet: Donnerstag, 27. Januar 2005 23:34
Betreff: [pure-silver] Re: spotting on RC
> Becky
> First, if you are talking about the print exchange, I think you are
talking
> about, the exchange is aiming for FB prints and not RC. I think Dave has
> been the only exception to this so far. The exchange group would much
prefer
> FB prints, even that RC is accepted.
>
> Nevertheless, spotting RC (and FB) is much improved by a post-wash
treatment
> of the print in Agfa Sistan. The Œrepelling¹ behavior is much reduced that
> way.
>
> Looking forward to your FB prints :)
>
>
>
>
>
> Regards
>
>
>
> Ralph W. Lambrecht
>
>
>
>
>
>
>
> On 1/27/05 8:00 PM, "AhYouBecky@xxxxxxx" <AhYouBecky@xxxxxxx> wrote:
>
> > I have a problem.... I've always used FB papers but I thought that I
would
> > try using RC because I'm part of a print exchange. I thought that it
would
> > make
> > the task of printing several prints, easier. WRONG
> > Here's the situation:
> >
> > I used warm tone, VC peril RC
> >
> > I used a glass negative carrier to keep the negative flat because I knew
the
> > heat on the negative over an extended amount of time would cause it to
flex.
> > That was my first mistake. I cleaned the carrier but after the prints
dried,
> > there are a lot of tiny, tiny spots that I hadn't noticed when the print
was
> > wet.
> >
> > Before they had dried though, I sepia toned them and then selenium toned
> > them. Washing in between, of course.
> >
> > Now I'm stuck trying to spot tone dual-toned prints on RC! grrrrrrrrrrr
> >
> > The RC isn't letting me spot them in the way that FB papers do. Also,
I'm not
> > sure that the sepia spot toner is the right color. HELP :)
> >
> > Becky Lynn
> >
> >
> >
============================================================================
==
> > ===============================
> > To unsubscribe from this list, go to www.freelists.org and logon to your
> > account (the same e-mail address and password you set-up when you
subscribed,)
> > and unsubscribe from there.
>
>
>
============================================================================
=================================
> To unsubscribe from this list, go to www.freelists.org and logon to your
account (the same e-mail address and password you set-up when you
subscribed,) and unsubscribe from there.
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your
account (the same e-mail address and password you set-up when you subscribed,)
and unsubscribe from there.
Other related posts:
- » [pure-silver] Print exchange group
