Hi Nigel, Consider it done! Barrie > Hi Barrie, > > If possible Could you please send me a copy. > > Regards > Nigel > > In a message dated 19/07/2008 19:57:11 GMT Daylight Time, > bpduo@xxxxxxxxxxxxx writes: > Alan, > > I can't refer you to the article by Jim Ewins but I have drawings of said > lubricator which I could scan and send to you. I would add that it is an > excellent design. > > Regards, > > > Barrie > > >> Jim Ewins described an oil pump, similar to the LBSC one but with two o >> rings. >> I am fairly sure it was in EIM, but cant find it. >> >> Can anyone direct me to the magazine / issue please. >> >> Alan >> >> MODEL ENGINEERING DISCUSSION LIST. >> >> To UNSUBSCRIBE from this list, send a blank email to, >> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the >> subject >> line. >> > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. > > > > > > > > > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. > MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.