Alan, They're gone! Barrie ----- Original Message ----- From: "Alan Stepney" <alan@xxxxxxxxxxxxxxxx> To: <modeleng@xxxxxxxxxxxxx> Sent: Saturday, July 19, 2008 9:28 PM Subject: [modeleng] Re: Jim Ewins oil pump > Yes please Barrie. > Alan > ----- Original Message ----- > From: "Barrie Purslow" <bpduo@xxxxxxxxxxxxx> > To: <modeleng@xxxxxxxxxxxxx> > Sent: Saturday, July 19, 2008 7:56 PM > Subject: [modeleng] Re: Jim Ewins oil pump > > > Alan, > > I can't refer you to the article by Jim Ewins but I have drawings of said > lubricator which I could scan and send to you. I would add that it is an > excellent design. > > Regards, > > > Barrie > > >> Jim Ewins described an oil pump, similar to the LBSC one but with two o >> rings. >> I am fairly sure it was in EIM, but cant find it. >> >> Can anyone direct me to the magazine / issue please. >> >> Alan >> >> MODEL ENGINEERING DISCUSSION LIST. >> >> To UNSUBSCRIBE from this list, send a blank email to, >> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject >> line. >> > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. > MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.