Yes I didn't push them. I am tidying up a few things. I will push them soon. - f Sent from BlackBerry® on Airtel -----Original Message----- From: Thomas Sarlandie <thomas@xxxxxxxxxxxxx> Sender: minima-bounce@xxxxxxxxxxxxx Date: Thu, 20 Mar 2014 19:27:41 To: minima@xxxxxxxxxxxxx<minima@xxxxxxxxxxxxx> Reply-To: minima@xxxxxxxxxxxxx Subject: [minima] Re: The LPF no change Farhan, I don't think you ever pushed to github an updated version of the code that sends the pulses to the CD4070. Did you write that? thomas On Thu, Mar 20, 2014 at 8:49 AM, Leonardo Ramirez <ea7kb@xxxxxxxxxxx> wrote: > Ok thanks. > And where I have to take the pulse in the Arduino of the Minima? > > ------------------------------ > Subject: [minima] Re: The LPF no change > To: minima@xxxxxxxxxxxxx > From: farhanbox@xxxxxxxxx > Date: Thu, 20 Mar 2014 13:18:36 +0000 > > > You hcave ground the clock enable pin. Sorry about the error in the > circuit. I ma been terribly QRL. Can someone else update the circuit? It is > on the wiki. > - f > Sent from BlackBerry® on Airtel > ------------------------------ > *From: * Leonardo Ramirez <ea7kb@xxxxxxxxxxx> > *Sender: * minima-bounce@xxxxxxxxxxxxx > *Date: *Thu, 20 Mar 2014 13:54:36 +0100 > *To: *minima@xxxxxxxxxxxxx<minima@xxxxxxxxxxxxx> > *ReplyTo: * minima@xxxxxxxxxxxxx > *Subject: *[minima] The LPF no change > > Hi . > I mounted the RF386 amp and works well but does not change the CD4017 > the LPF > What band selector line I need to use? > I connected to PD5 but does not change. > > Best Regards. > > Leo / EA7KB >