Hi 1. I bought some chips with Arduino bootloader already loaded from eBay months ago and used one of them 2. no - I put chip into Uno board, programmed it and then pulled out chip and put into stripboard socket - I will use usb to serial later 3. yes - but i modified the wire.h library files as I documented on the wiki. I also changed the function button code as discussed on the forum. I can publish code changes again if needed. M On 28 January 2014 15:28, pakdeDar <pakdedarmantaoye@xxxxxxxxx> wrote: > Hello Mark, > > Please tell me that you have succesfully load the Radiono.ino sketch to > the processor board you build on stripboard and boxed. All the controller > feature works well is'n it ? > > Inform me : > > 1. What kind of bootloader you loaded to the Atmega chip > > 2. Did you use usb to serial port cable converter to load the sketch ? > > 3. The sketch developed by Farhan and upload in GitHub was completely > works without some revision. > > I will start to build like your's while I get to find Si570. > > Regards, > > Sudarmanta - YC1DCN > > Kaspa-kaspaanlayauw ® > > -----Original Message----- > From: Mark G0MGX <mark.g0mgx@xxxxxxxxx> > Sender: minima-bounce@xxxxxxxxxxxxx > Date: Sun, 26 Jan 2014 08:47:27 > To: <minima@xxxxxxxxxxxxx> > Reply-To: minima@xxxxxxxxxxxxx > Subject: [minima] Some Updates from Me! > > Morning Team > > I've started to construct a case for the project here: > > http://g0mgx.blogspot.co.uk/2014/01/boxing-to-minima.html > > and also built the processor board on some stripboard and mounted it > behind the LCD here: > > http://g0mgx.blogspot.co.uk/2014/01/minima-processor-board.html > > Mark > G0MGX > >