[minima] Radiono serial port commands
- From: Ashhar Farhan <farhanbox@xxxxxxxxx>
- To: minima@xxxxxxxxxxxxx
- Date: Mon, 10 Feb 2014 09:05:54 +0530
I am proposing that we write a set of commands that can be used to tune and
control the minima.
Each command line starts with a letter, it is optionally followed by a
digits and it ends with a new line.
Some commands receive a response. The response can be in multiple lines.
Every line starts with a letter followed by zero or more numbers separated
by commas.
So, here is a tentative list:
Requests:
"s\n" : asks for the status of the transceiver. The status can be several
lines of text until two repetitive new lines "\n\n"
"t14200000\n" places the Minima in transmit mode at 14200KHz. If the
frequency is not supplied, it transmits at the current frequency.
"r\n" puts the minima into receive mode at the current frequency
"r7040000\n" puts the minima to receive at 7.040 MHz
"f" fetches the current frequency
"x115420000\n" sets the internal crystal frequency to 115.42 MHz
"m\n" puts minima into morse code mode. the following characters are all
sent out as morse until a new line (morse code doesn't have a newline!)
"c1\n" puts out a carrier in tx mode (to tune-up etc. at the current
frequency)
"c0\n" switches off the carrier.
"u1\n" upper side band
"u0\n" lower side band.
any more?
- f
Other related posts:
