well I am not saying that it's the mixer going in autooscillation but does the trim in some way induce some kind of noise that I ear like a strong whistle in the speaker? I am not able to find where it's produced. I already tried to pug more capacitors on the 78L05 regulator but no result. 73 Giorgio Inviato da iPhone Il giorno 27/feb/2014, alle ore 12:00, farhanbox@xxxxxxxxx ha scritto: > The mixer is not active. It cannot go into oscillations at all! > - f > Sent from BlackBerry® on Airtel > > -----Original Message----- > From: Ik3nlk <mail@xxxxxxxxxx> > Sender: minima-bounce@xxxxxxxxxxxxx > Date: Thu, 27 Feb 2014 10:45:06 > To: minima@xxxxxxxxxxxxx<minima@xxxxxxxxxxxxx> > Reply-To: minima@xxxxxxxxxxxxx > Subject: [minima] Re: J310 mixer question > > Thank you Steve and Jerry! I had this doubt because the mixer go in > autooscillation when I turn the balance trimmer. Is it ok that I get those > oscillations when I set the trim? > > 73 de Giorgio > > Inviato da iPhone > > Il giorno 26/feb/2014, alle ore 02:14, <jerry@xxxxxxxxxxxxxxxx> ha scritto: > >> On the schematic the arrow for the gate is centered meaning the device >> is symmetrical. The drain and source can be switched with no ill >> effects. Jerry >> >> K5LRU >> Harwood, Texas >> >>> -------- Original Message -------- >>> Subject: [minima] Re: J310 mixer question >>> From: "Steve VK2SJA" <vk2sja@xxxxxxxxxxx> >>> Date: Tue, February 25, 2014 4:51 pm >>> To: minima@xxxxxxxxxxxxx >>> >>> >>> Hi Giorgio, >>> >>> Short answer. Does not matter. The J310 device is "symmetrical". >>> >>> For the long answer, look for the section entitled "Symmetrical >>> Construction" in the link below:- >>> >>> http://www.cliftonlaboratories.com/jfet_variation.htm >>> >>> 73, Steve. >>> >>> >>>> Hi >>>> I have a doubt about J310 connections: >>>> >>>> are the 2 pin connected together to the trimmer via 4k7 resistor the >>>> drains or sources? >>>> >>>> Sorry if this question was already andwered but I don't find any info. >>>> >>>> Thanks >>>> >>>> 73 Giorgio >>>> >>>> Inviato da iPhone >