Thank you Steve and Jerry! I had this doubt because the mixer go in autooscillation when I turn the balance trimmer. Is it ok that I get those oscillations when I set the trim? 73 de Giorgio Inviato da iPhone Il giorno 26/feb/2014, alle ore 02:14, <jerry@xxxxxxxxxxxxxxxx> ha scritto: > On the schematic the arrow for the gate is centered meaning the device > is symmetrical. The drain and source can be switched with no ill > effects. Jerry > > K5LRU > Harwood, Texas > >> -------- Original Message -------- >> Subject: [minima] Re: J310 mixer question >> From: "Steve VK2SJA" <vk2sja@xxxxxxxxxxx> >> Date: Tue, February 25, 2014 4:51 pm >> To: minima@xxxxxxxxxxxxx >> >> >> Hi Giorgio, >> >> Short answer. Does not matter. The J310 device is "symmetrical". >> >> For the long answer, look for the section entitled "Symmetrical >> Construction" in the link below:- >> >> http://www.cliftonlaboratories.com/jfet_variation.htm >> >> 73, Steve. >> >> >>> Hi >>> I have a doubt about J310 connections: >>> >>> are the 2 pin connected together to the trimmer via 4k7 resistor the >>> drains or sources? >>> >>> Sorry if this question was already andwered but I don't find any info. >>> >>> Thanks >>> >>> 73 Giorgio >>> >>> Inviato da iPhone >