It's mostly annoying...
I added a bug on GitHub
On Tue, 4 Dec 2018, 04:24 Kevin O'Connor, <kevin@xxxxxxxxxxxx> wrote:
On Mon, Dec 03, 2018 at 08:17:22PM +0100, Martin Malmqvist wrote:
It works but as I wrote the circle isn't centered
The gcode center (x0y0) is the center point of the three towers. If
your bed is a little off, maybe it's just the bed being not centered?
If you've got a good first layer and the resulting prints are
dimensionally correct (it looks like you've run the advanced delta
calibrate), then I wouldn't worry too much if the bed has an xy
offset.
-Kevin