Hey guys, it is possible. Check out check out http://forums.isaserver.org/ultimatebb.cgi?ubb=get_topic;f=1;t=000916 HTH, Stefaan -----Original Message----- From: John Tolmachoff [mailto:isalist@xxxxxxxxxxxx] Sent: dinsdag 18 juni 2002 23:58 To: [ISAserver.org Discussion List] Subject: [isalist] RE: Cisco VPN Dialer http://www.ISAserver.org Client 2 is on Internal NAT with a private IP, correct? ISA is doing NAT, correct? Please read the following: http://support.microsoft.com/search/preview.aspx?scid=kb;en-us;Q317509 http://support.microsoft.com/search/preview.aspx?scid=kb;en-us;Q259335 If you are trying to create a VPN tunnel using IPsec from Client 2 on the internal LAN which has a private IP address, through the ISA which is doing NAT, to the Cisco (client 1), unless someone can correct me, it will not work. This is a restriction of NAT and IPsec. Why do you need a VPN tunnel from an internal client to the router? John Tolmachoff IT Manager, Network Engineer RelianceSoft, Inc. Fullerton, CA 92835 www.reliancesoft.com -----Original Message----- From: Amit Gokani [mailto:amitgokani@xxxxxxxxxxxx] Sent: Tuesday, June 18, 2002 1:48 PM To: [ISAserver.org Discussion List] Subject: [isalist] Cisco VPN Dialer http://www.ISAserver.org I know the following information is a bit vague but this is all I have (so far) Server1 (CISCO FIREWALL).....Client1 | | | Server2 (ISA).....PC2 Client2 has got Cisco VPN Dialer setup with: Enable Transparent Tunnelling (Allow IPSec over UDP (NAT/PAT) I have been told the following information: Setup UDP Port 500 Protocol 47 I have tried this but to no avail...And am getting presurised in getting it working (yesterday) Please could someone advise what I require opening/setting on the ISA firewall? (I will answer as many questions as I can to help) Again, I know it is not much to go on but all assistance is much appreciated. Regards, AMIT..... ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: isalist@xxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: stefaan.pouseele@xxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')