[Ilugc] Require help on Access point and the wireless router.
- From: mohan.tux@xxxxxxxxx (Mohan Sundaram)
- Date: Mon Mar 1 20:18:03 2010
On Mon, Mar 1, 2010 at 6:58 PM, sri kumaran <cyberdyne_indiya@xxxxxxxxx> wrote:
hi,
?I am not an expert but i can tell what you can install to get the best.Get
two wireless
access points , put them on two different extreme channels and configure
them in? the
bridge mode and connect these AP to a switch which goes to your dsl modem
directly.Divide the expected users to use the two channels ..If required go
for three access
points if you sufferer from serious speed problems.Also try to put the
access pionts in the
center of the room spaced a few feets from each other.Keep the group updated!
Most commercially available access points do not support bridging mode
between the WAN ethernet port and the wireless subsystem. Bridging
will work across wireless and the LAN ethernet ports only. Load
distribution is difficult (may not matter though given thin WAN
bandwidth). Availability and support might skew your decision to this
solution, nevertheless.
To avoid these, I'd suggest a wifi mesh. Look up www.meraki.com. Last
I knew, they were sold at $50 apiece. Do not have much idea about
local availability of similar systems.
-- Mohan Sundaram
Other related posts:
