[PCB_FORUM] Re: Suppressing pads
- From: "CHRIS LANZA" <chris.lanza@xxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Thu, 9 Sep 2010 11:08:20 -0500
May be. Also may have to have expert
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gennadiy
Kiryukhin
Sent: Thursday, September 09, 2010 11:06 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Suppressing pads
Under Setup I have: Drawing Size, Drawing Options, Text Size, Grids,
Subclasses, Define BB Via, Constraints, Property Definitions, Define
Lists, Areas, Outlines, and User Prefs.
Is it specific to a certain version/license?
CHRIS LANZA wrote:
> Under setup there is pad suppression. You suppress vias also
>
> -----Original Message-----
> From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
> [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gennadiy
> Kiryukhin
> Sent: Thursday, September 09, 2010 10:47 AM
> To: icu-pcb-forum@xxxxxxxxxxxxx
> Subject: [PCB_FORUM] Suppressing pads
>
> I have a BGA with ground plane under it. The problem I have is that
the
> ball pitch is too small to create a single ground (power)plane under
it
> with all the via pads unsuppressed. See picture attached. Instead of
> having one GND plane I have small islands. Is there any way to
suppress
> pads on vias that don't have connections on that plane so that I have
> more room to create a single GND plane?
>
> Thank you.
>
--
Gennadiy Kiryukhin
Development Engineer
ATSI
8157 US Route 50
Athens, OH 45701
Phone: (740) 592-2874
Fax (740) 594-2875
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
//www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
//www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
Other related posts:
