Check your parameters if you have the parameters set for thermals on surface pads it will not fill. Either change the parameters on the shape to "ful lcontact" or add the property to the pin. Gerry Meier Sr. PCB Designer Freedom CAD Services, Inc. Voice: (603) 864-1300 x1350 AL Voice: (256) 417-6944 Email: gerry.meier@xxxxxxxxxxxxxx visit our website at<http://www.freedomcad.com -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of chris.ball@xxxxxxxxx Sent: Thursday, December 08, 2005 9:06 AM To: icu-pcb-forum@xxxxxxxxxxxxx; Ed.Caldwell@xxxxxxxxxx Subject: [PCB_FORUM] Re: Shape not filling into pin I can't tell from the pic how far down your plane shape ends. I've had this happen to me, and extending plane shape well into the pin seemed to fix it. Good Luck, -Chris Ed Caldwell <Ed.Caldwell@xxxxxxxxxx> To: <icu-pcb-forum@xxxxxxxxxxxxx> Sent by: cc: icu-pcb-forum-bounce@freel Subject: [PCB_FORUM] Shape not filling ists.org into pin 12/08/2005 08:47 AM Please respond to icu-pcb-forum Allegro Studio 15.2 - Notice the third pin from the left in the picture below - the pin is 12 mils wide - the shape fill line is 5 mils wide - the pin and the shape fill are the same net - the shape thermal relief is set to full contact - the red line is the shape border I can add a 10 mil trace from the pin into the shape fill with no DRC error. Why the no fill into the pin? I expect it is something simple I am overlooking. (Embedded image moved to file: pic12074.gif) Thanks, Ed Voice: 770-622-8707 Email: mailto:ed.caldwell@xxxxxxxxxx ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------