[PCB_FORUM] Re: Shape not filling into pin
- From: "Vince Di Lello" <vince.dilello@xxxxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Thu, 8 Dec 2005 06:05:00 -0800
Ed, select the shape, RMB, select Parameters, 4th tab should be Thermal
Relief Connects - set the SMD Pins to FULL CONTACT. Hope that helps.
Vincent Di Lello, CID+
Senior CAD Designer
Kaleidescape Canada, Inc.
vdilello@xxxxxxxxxxxxxxxx
(v) 519.772.6418
(f) 519.772.6401
www.kaleidescape.com
________________________________
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Ed Caldwell
Sent: Thursday, December 08, 2005 8:48 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Shape not filling into pin
Allegro Studio 15.2 - Notice the third pin from the left in the picture
below - the pin is 12 mils wide - the shape fill line is 5 mils wide -
the pin and the shape fill are the same net - the shape thermal relief
is set to full contact - the red line is the shape border
I can add a 10 mil trace from the pin into the shape fill with no DRC
error.
Why the no fill into the pin? I expect it is something simple I am
overlooking.
Thanks,
Ed
Voice: 770-622-8707
Email: mailto:ed.caldwell@xxxxxxxxxx
Other related posts:
