Mike, Can you try upgrading to the latest 16.2 ISR? A hotfix was issued for this problem on Dec 20th. Ed -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Crittenden, Mike Sent: Wednesday, January 07, 2009 1:24 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] SPB16.2 - Can't change impedance value in Cross section menu Hello All, Just upgraded to 16.2 and when I try to chance the impedance value in the cross section menu, it is stuck on 60 ohms. Any suggestions? Thanks! Mike Crittenden Technology Services Corporation, Phase IV Operation (256) 535-2118 ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------