[PCB_FORUM] Pin numbers into capture
- From: "sureshbabu" <suresh@xxxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Mon, 21 Jun 2004 09:50:37 +0530
Dear Forum,
Anyway the Pin-numbers in Allegro could be read into Capture for mapping
with the Pin Names when building a Part in Capture?
Cadence Concept has a way of importing Pin-numbers directly from Allegro
Footprint (.psm) into the Part Editor. This way entering the Pin-numbers twice
in Allegro and once again in Capture could be avoided.
I'm aware that Pin-numbers falling in a sequence like 1,2,3,... could be
done with ease in Capture but what if the Pin-numbers are Alphabetic or
Alphanumeric?
Ex. S1_1, DPS1_1FS, RST etc.
Regards,
Radha Krishnan G.
Other related posts:
- » [PCB_FORUM] Pin numbers into capture
