If the mounting hole will be used in different locations where different sides extend over the route keepin area in different sides and distances, I made the pad used a shape. Then in Allegro I can edit the shape of the pad as necessary per the situation. From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Bob McCreight Sent: Wednesday, September 11, 2013 7:32 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Pad Clipping? Hello Allegro Gurus, As is the norm, I am racing the midnight hour :-) <West Coast> I have a few mounting holes whos' pads extend into (make that outside) the Route KeepIn shape. What is the best method for clipping the copper on these features? Thanks in advance for your excellent suggestions! Bob