[PCB_FORUM] Drill Chart on Allegro 15.2
- From: "Kipnis, Oleg" <Oleg.Kipnis@xxxxxxxxxx>
- To: "'icu-pcb-forum@xxxxxxxxxxxxx'" <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Wed, 15 Jun 2005 08:57:31 -0700
Hello Allegro Gurus,
Our pcbfab vendor does not require to have Drill Chart table on drill gerber
layer
(they use drill tape),
there fore before Allegro V15.2 we just turn OF Ncdrill_Legend layer.
Now (on Allegro V15.2) program creates as a default Nclegend1-6 layer and
puts Drill Chart and Ncdrill figures on the same (Nclegend1-6) layer.
So question is: is the way to put Drill Chart on different layer (in order
not to
show it for fabvendor)? Other wise I have to delete Drill chart and leave
Ncdrill figures only before creating gerber.
Thank you in advance.
Regards,
OLEG KIPNIS
x8286
PCB Layout Designer
SMART Modular Technologies, Inc.
4211 Starboard Drive
Fremont, CA 94538
Direct: 510-624-8286 Fax: 510-624-8195
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list please login at
//www.freelists.org. Our list name is icu-pcb-forum
or go to //www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
Want to post a job listing ? DON'T DO IT HERE!
Better yet, join our jobs listing forum.
SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx
POST: icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------
Other related posts:
