Hi You can try to select the shape, defer fill and then done. This will regenerate the shape and may clean up the errors. David Kelly davidkel@xxxxxxxxx 720-562-6316 -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Nha Le Sent: Wednesday, July 02, 2008 4:39 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Artwork error Hi all, When I create artwork, an error message is displayed says that: ERROR: aborting film - Shape with first seg=(644.327 503.002) [layer=TOP] has a void with extents [(-625.002 574.998) (525.002 655.002)] that touches another shape with first seg=(-555.945 639.370). Manually resolve problem. ERROR: aborting film - artwork will not be generated! Error in TOP--halting output. Artwork file not generated. *** ERROR with TOP How can I abort this error and generate this artwork file? Thanks in advance. ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------