Paul, MidwestCAD does this all the time. They have software that converts MGC to/from CDS. Send your .brd file to jims@xxxxxxxxxxxxxx and he will get you a quote. These guys are honest, reasonable and the second best SB after KAW. ----- Original Message ----- From: Paul Gingras To: icu-pcb-forum@xxxxxxxxxxxxx Sent: Thursday, July 20, 2006 2:38 PM Subject: [PCB_FORUM] Allegro 2 Pads Wonder if anyone out there knows of a method or could point me in the direction in getting me from Allegro to Pads Power PCB. Thannkin you all in advance for any comments or suggestions!! PAUL Paul J Gingras KAW USA, LTD. "Real People .... Real Solutions" Voice: 603 886 8711 x200 Fax: 603 881 8763 Cell: 603 305 1475 Email: paul@xxxxxxx Web: www.kaw.com 39 Simon St. Bldg.#4 Nashua, NH 03060 Confidentiality Notice: This email and any accompanying documents contain information that is confidential, privileged or exempt from disclosure under applicable law and is intended for the exclusive use of the addressee. This information is private and protected by law. If you are not the intended recipient, or have received this email in error, you are hereby notified that any disclosure, copying, distribution or use of the contents of this document in any manner is strictly prohibited.