#9106: Black screen with 3D Rage Pro AGP 1X/2X ------------------------------------+----------------------------- Reporter: Morbid | Owner: gerald.zajac Type: bug | Status: new Priority: normal | Milestone: R1 Component: Drivers/Graphics/ati | Version: R1/Development Resolution: | Keywords: ATI 3d Rage pro Blocked By: | Blocking: Has a Patch: 0 | Platform: x86 ------------------------------------+----------------------------- Comment (by gerald.zajac): I have tested the following two ati video cards with haiku releases r44220 and r44660: 3D Rage Pro, chip ID: 0x4742 3D Rage IIC, chip ID: 0x475A The video worked fine under both releases with either video card. I used the ati video driver that came with these releases, and did not alter the driver in any way. After looking at the syslog's attached to this report, it appeared to me that Morbid must be using the Zeta ati video driver since I did not see any output from the ati driver/accelerant in the syslog's; and Morbid did confirm that with his comment above. Thus, since Haiku's ati video driver was not used, this bug report should be closed. It should be noted that when using the above listed ati video cards with some computers, the screen will be blank when the boot screen is normally displayed. However, the video displays normally with these ati video cards when the boot screen finishes, and the normal Haiku display is started. It is my understanding that video drivers are not used when the boot screen is displayed. -- Ticket URL: <http://dev.haiku-os.org/ticket/9106#comment:8> Haiku <http://dev.haiku-os.org> Haiku - the operating system.