The AW connects to the node bus via ethernet so it should be le0 , but you could also have problems with your DNBI , you should reboot your DNBI as well.=20 -----Original Message----- From: foxboro-bounce@xxxxxxxxxxxxx [mailto:foxboro-bounce@xxxxxxxxxxxxx] On Behalf Of Ajay.Tathgir@xxxxxxx Sent: Friday, February 11, 2005 1:15 AM To: foxboro@xxxxxxxxxxxxx Subject: [foxboro] WP51B won't communicate Hi! All I have a WP51B which won't communicate on the nodebus. It does boot up, without any error messages, but that's it. If I do a fist, under error I get "Not found (-1)". Where do i start looking, is it a le0 problem, or a serial port ? Thanks & Regards Ajay Tathgir Reliance Industries Limited Mumbai - India =20 =20 _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html =20 foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: = mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Djoin to unsubscribe: = mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Dleave =20 _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave