Hi Gary, If your Everest came from TSI, then it may even be pre Version 2. Can I suggest you try the Generic, or Generic Interpoint embosser option, rather than Index Everest? Unfortunately there are not many of these models left. George. > -----Original Message----- > From: duxuser-bounce@xxxxxxxxxxxxx > [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of > gpatterson002@xxxxxxxxx > Sent: 02 November 2004 00:50 > To: duxuser@xxxxxxxxxxxxx > Subject: [duxuser] index everest-d configuration help wanted > > I am unable to configure my Index Everest-D embosser in > Duxbury V10.5 The embosser is a model 2 and came from TSI. > > I have spoken to Duxbury Tech support and Sighted > Electronics. Any suggestions would be appreciated. > > Gary > > * * * > * This message is via list duxuser at freelists.org. > * To unsubscribe, send a blank message with > * unsubscribe > * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also > * subscribe, unsubscribe, and set vacation mode and other subscription > * options by visiting //www.freelists.org. The list archive > * is also located there. > * Duxbury Systems' web site is http://www.duxburysystems.com > * * * > This Message has been scanned for viruses by McAfee Groupshield. * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *