Hi Carmela,
Your DBT settings are fine, so don't touch them. To change the top-of-form
on the Juliet, do the following:
1. Take the embosser off line.
2. Assuming that you're using Menu 1, select it by entering 0.1E. If
you're using a different menu, substitute it's number in the above
expression. For Menu 2, you'd enter 0.2E.
3. To change top-of-form to 1/2 inch from the top of the page, enter 30.5E.
4. Exit the menu and save your changes by entering 1.1E. The embosser
will go through its self-test sequence and come back on line.
5. Take the embosser off line again, and set top of form by entering
2E. You will now have the top and bottom margins you want. Let me know
how it goes.
Steve
On Thursday 3/4/04 06:56 Meladuci01@xxxxxxxxxxxxx wrote:
Hi Steve,
I don't know the form settings in juliet but in DBT global menu I have the top margin and line at 0, the desired lines 25 and desired spaces at 40. On the paper I am getting 11/16 at the top and 6/16 at the bottom, the paper starts at the 6th hole.
I don't know what to do if I have to change the settings in Juliet.
I appreciate any help. I have to emboss the Trial Manuscript soon and the Library of Congress requires 1/2 half inch at the bottom of the document.
Thank you, Carmela Morrison
* * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *
