I use a Juliet Classic with 8-1/2 paper too. First, make sure your paper guides are far enough to the left. My settings are as follows: In Duxbury max characters is 32 and desired is 30. On the Juliet 15.4 and 14.35. See if these work. -----Original Message----- From: Rlr1999@xxxxxxx [SMTP:Rlr1999@xxxxxxx] Sent: Sunday, November 02, 2003 7:05 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] A basic margin question << File: ATT00016.htm >> Hi Everyone I have a Juliet Classic embosser, DBT V 10.4 translator and Word. My wife is blind and I am trying to set this up so I can emboss letters, recipes etc. for her. I cannot get past setting up the margins for regular printer paper. (8 1/2 wide). I followed the instructions which came with the Juliet, but I am still getting embossing off the right side. I believe what I put into the emboser was 15.1 and 14.30. I checked the settings in DBT and they are Max 30, desired 28. (I have tried various combinations of these, none work.) I want to use the printer paper for one time reading for her. I also have standard braille paper for items she will use repeatedly. I would appreciate any help in what I am doing wrong. Thank you very much. Roy * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *